Mellerware PALERMO 29002 Instrukcja Użytkownika Pobierz pdf (Strona 9)

For the section of making drip filter

coffee

Note: the switch referring on the

following section is the switch for drip

filter coffee.

1. Fill the tank with water and descaler

to the MAX level (Approximate 1.25L,

the scale of water to descaler is 4:1).

Please use “household descaler”.

You can also use citric acid instead

of descaler (the one hundred parts of

water and three parts of citric acid).

Tip: leave the solution in the tank for

15 minutes before brewing.

Note: Descale without using coffee

powder.

2. Place the large jug onto warming

plate and pay attention to let the

centre of large jug to align with that

of brewing basket.

3. Pressing the switch to the “I”

position, the indicator will be

illuminated. After a while, water will

drip out automatically.

4. After the coffee maker has

percolated the equivalent of one cup,

press the switch to the “O” position

to stop the water.

5. Leave the solution to work for 15

minutes, and then repeat the steps

3-5 again.

6. Turn the appliance on by pressing

the switch to the “I” position and run

off the water until the water tank is

completely empty.

7. Rinse by operating the coffee maker

with clean water at least 3 times.

For the section of making espresso

coffee

Note: the switch being referred to in the

following section is the switch for the

espresso coffee.

1. To make sure your coffee maker is

operating efficiently, and producing

the best flavour of coffee, the internal

piping requires periodic cleaning.

You should clean away the mineral

deposits every 2-3 months.

2. Fill the boiler unit with water

and descaler to the MAX level

(Approximate 0.24L, the scale of

water to descaler is 4:1). Please use

“household descaler”. You can also

use citric acid instead of descaler

(the one hundred parts of water

and three parts of citric acid). Tip:

leave the solution in the boiler for 15

minutes before brewing.

3. Brew the water according to the

program of making espresso coffee

without coffee powder in the filter.

4. Turn the brew strength control knob

to “STRONG” or “LIGHT” position,

then turn the switch on by pressing it

to the “I” position and approximately

3 min later the water will flow out.

After making 2 espresso sized cups

of hot water, turn off the switch by

pressing it to the “O” position.

5. Turn brew strength control knob

to the “STEAM” position. Press

the switch to the “I” position. Wait

approximately 3 minutes to generate

the steam and release the steam for

approximately 2 minutes. Afterwards,

turn off the switch by pressing it to

the “O” position.

6. Restart the unit and repeat steps 3-5

at least 3 times, but be sure to re-fill

with water.

7. Then turn the brew strength control

knob to the “STRONG” or “LIGHT”

position, and brew until no descaler

is left.

8. Rinse the system by repeating steps

3-5 with clean water. Repeat this

3 times until no water is left in the

boiler unit.

9. Repeat step 8 at least 3 times to

make sure steam pipe is clean.

MW_EX29002_Palermo_IM.indd 9MW_EX29002_Palermo_IM.indd 9 10/29/2008 12:05:32 PM10/29/2008 12:05:32 PM

1 2 3 4 5 6 7 8 9 10 11

Komentarze do niniejszej Instrukcji

Brak uwag