Mellerware PALERMO 29002 Instrukcja Użytkownika Pobierz pdf (Strona 6)

permanent nylon filter with a

measuring spoon (Fig. 6). Use

one spoon (15g) of ground coffee

powder per cup. You can adjust

according to your taste.

4. Close the tank cover. Place the large

jug on the warming plate directly

under the drip filter coffee section.

(Fig. 7)

5. Plug the power cord into the wall

socket and press the switch to

the “I” position, the switch will

illuminate. The coffee maker will

begin operating. You may stop the

brewing by pressing the switch to the

“O” position at any time. The coffee

maker will continue brewing once

pressing the switch to the “I” position

again.

Note: at any time, you can take out

the large jug to serve, but the time

should not exceed 20 seconds.

Otherwise, the water will overflow

out of the filter.

6. The coffee will keep warm on the

warming plate if you do not switch off

the coffee maker. The coffee maker

will automatically switch off after two

hours, as a safety feature, so that it

does not overheat.

STOP AND SERVE FUNCTION

This automatically stops the flow of

brewed coffee through the filter if the

glass jug is removed from the warming

plate during the brewing cycle. You

have about 20 seconds between the

removal of the glass jug and it being

reinserted back onto the warming plate.

The stop and serve closes off the filter

so effectively that there is virtually no

coffee dripping onto the warming plate.

Once the glass jug is replaced, the

brewing process and the flow of coffee

into the glass jug can resume.

MAKE ESPRESSO COFFEE

1. Turn the boiler unit cover in an anti-

clockwise direction to open the boiler

unit (see Figure A), then fill it with an

adequate amount of drinking water.

Purified drinking water provides a

better taste and flavour of coffee.

(Fig. 8 & 9)

Note: Always switch off the power and

remove the plug from the wall

socket before filling it with water.

Ensure that the water does not

overflow out of the boiler unit.

2. Turn the boiler unit cover in a

clockwise direction to tightly close

it (see Figure A & 10), then turn the

steam control knob in a clockwise

direction to ensure that the steam

control knob is tightly closed (see

Figure B). If it is not closed, the boiler

unit will not build up pressure and

the water will flow out of the steam

nozzle.

Figure A

Figure B

Figure C

STEAM

LIGHT

STRONG

STEAM

C

C

LOSE

LOSE

OPEN

OPEN

MW_EX29002_Palermo_IM.indd 6MW_EX29002_Palermo_IM.indd 6 10/29/2008 12:05:32 PM10/29/2008 12:05:32 PM

1 2 3 4 5 6 7 8 9 10 11

Komentarze do niniejszej Instrukcji

Brak uwag